3 Series E92 M3 (S65) COUPE
When correctly adjusted, feeler gauge will jam between stop
screw (1) and actuator (2) of throttle valve.
Perform check on each throttle valve assembly.
Performing throttle valve basic setting:
A basic setting must be performed if the gap is larger than
0.05 mm at one or more throttle valve assemblies.
Note:
To perform correct throttle valve setting, it is necessary to slacken
all the screw connections (3) of the actuating lever (2) with the
actuating shaft (1). (Replace nuts).
However, if increased play is ascertained, the corresponding
cylinder bank must be reset.
Do not slacken the screw connections of the actuating levers for
the long pull rods.
The long pull rods must not be disengaged from the actuating
levers for the setting procedure.
To slacken screw connection of actuating lever (1), grip
screw (3) and release nut (2). (Replace nuts).
Release screw connections of actuating levers of throttle valve
assemblies 1-4 and 5-8.
Adjusting a throttle valve assembly:
Move actuating lever (1) in direction of arrow, i.e. "close throttle
valve", until actuator (2) of throttle valve rests without play on
stop screw (3).
Important!
Do not exert any pressure!
RA Performing throttle valve basic setting (S65)
BMW AG - TIS
21.02.2013 19:39
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
