3 Series E92 M3 (S65) COUPE
Tighten down screw connection of actuating lever (1) again to
actuating shaft. Observe the following instructions in so doing:
-
Use nuts only once.
-
When pretightening screw connection (approx. 5 Nm), hold
actuating lever (1) of throttle valve in direction of arrow at
"close throttle valve".
-
Only turn nut and grip screw.
-
To screw down, use two open-end wrenches which are to be
placed at right angles to actuating shaft.
In this way, no lever action is exerted on the throttle valve
mechanism; such torque would impair the quality of
adjustment.
-
After pretightening actuating lever, actuate throttle valve
several times at full load.
Note:
If necessary, carry out adjustment with a second person.
Adjusting throttle valve assemblies 1 - 4 and 5 - 8:
The previously described procedure applies to adjusting/setting
throttle valve assemblies 1 - 4 and 5 - 8.
Adjust throttle valve assemblies 1 - 4 and 5 - 8 in sequence.
After successfully completing throttle valve basic setting and
checking, tighten down all screw connections of throttle valve
levers to specified torque 13 54 1AZ
.
Note:
After completing adjustment, it is necessary to check the throttle
valve basic setting!
If during the checking of one or more throttle valve assemblies
excessively large or small play is ascertained, it will be necessary
to perform the throttle valve basic setting again!
RA Performing throttle valve basic setting (S65)
BMW AG - TIS
21.02.2013 19:39
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
