3 Series E92 M3 (S65) COUPE
13 54 045
Removing and installing/sealing a throttle
valve assembly (S65)
Necessary preliminary tasks:
•
Read out fault memory of DME control unit
•
Switch off ignition
•
Follow instructions on connecting and disconnecting battery
•
Disconnect battery negative lead and cover
•
Remove intake air manifold
•
Remove all injectors
•
Release and raise cable duct for engine wiring harness; to do
so, partially remove engine wiring harness.
•
Disengage pull rods of throttle valve actuating motor.
Release all nuts of throttle valve flanges.
Release idle air hose connection.
Lift out throttle valve bank.
Release idle air duct on throttle valve bank.
RA Removing and installing/sealing a throttle valve assembly (S65)
BMW AG - TIS
21.02.2013 19:39
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
