3 Series E92 M3 (S65) COUPE
13 54 544
Removing and installing/replacing right Hall
sensor (S65)
Necessary preliminary tasks:
•
Read out fault memory of DME control unit
•
Switch off ignition
•
Remove intake air manifold
•
Remove secondary-air pump
•
Release and raise cable duct for engine wiring harness; for
information, refer to Removing engine wiring harness
Unlock and disconnect plug-in contact in wiring harness (not on
sensor).
Release screws and detach Hall sensor towards front.
Installation:
Make sure Hall sensor is installed in correct position.
Assemble engine.
Important!
After performing work on the throttle valve system (throttle
valve assembly, servomotor, Hall sensor), it is absolutely
essential to carry out a throttle valve actuator system test with
the BMW diagnosis system!
Function selection:
-
Complete vehicle
-
Drive
-
Engine electronics
-
Air supply
-
Throttle valves
-
Throttle valve actuator
RA Removing and installing/replacing right Hall sensor (S65)
BMW AG - TIS
21.02.2013 19:52
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
