3 Series E92 M3 (S65) COUPE
32 31 201
Replacing universal joint for upper section of
steering spindle
Warning!
Scalding hazard!
Only perform this work after engine has cooled down.
Important!
If the universal joint is separated from the lower section of the
steering spindle/steering column, the steering column switch
cluster may be damaged when the steering wheel is turned!
Necessary preliminary tasks:
•
Remove intake filter housing
•
Remove left or right microfilter housing lower section
•
Remove left ignition coil cover
Disconnect plug connection (1) and remove auxiliary water
pump (2) towards top from body.
Set down auxiliary water pump (2) on valve cover; if necessary,
remove water hoses from hose holder(s).
Installation:
Insert auxiliary water pump into body so that bearings slide
correctly in associated mountings.
Release clamping screws (1).
Move steering column in "top" and "extended" position.
Detach universal joint (2) first from steering column and then
from lower section of steering spindle.
Installation:
Clean thread to remove all remnants of screw securing adhesive.
Universal joint can only be attached in one position to steering
column and lower section of steering spindle.
Replace clamping screws.
RA Replacing universal joint for upper section of steering spindle
BMW AG - TIS
21.02.2013 22:15
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
