3 Series E92 M3 (S65) COUPE
Tighten down screw (1) to torque and then to angle of rotation
using special tool 00 9 120 .
Tightening torque 51 71 17AZ
.
Replacement:
•
Release studs (1) and feed suspension cross-brace
mounting (2) out of middle heater bulkhead (3)
If necessary, release suspension cross-brace grommets (4)
Installation:
Replace studs (1).
RA Removing and installing/replacing suspension cross-brace mounting
BMW AG - TIS
22.02.2013 03:56
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
