3 Series E93 320i (N46T) CONVER
Important!
Secure central bolt with special tool 11 8 180 only.
With engine removed, secure with special tool 11 9 260 .
Tighten down central bolt (1).
Tightening torque, 11 21 1AZ
.
Replace front crankshaft radial seal.
Note:
Picture shows a four-hole hub.
Secure engine in installation position.
Lower front axle support again.
Install oil sump.
Install front axle support.
Install vibration damper.
Install alternator drive belt.
Install positioning motor for eccentric shaft.
Assemble engine.
RA Replacing timing chain (N46T)
BMW AG - TIS
23.01.2013 18:06
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 10 -
