3 Series E93 320i (N46T) CONVER
Fit special tool 11 9 291 on exhaust camshaft.
Turn back special tool 11 9 293 .
Hold inlet camshaft with special tool 11 9 291 so that it rests
without a gap on cylinder head.
Insert screws and tighten down special tool 11 9 291 on
cylinder head.
Tighten down special tool 11 9 293 by hand until it is supported
on special tool 11 9 292 .
Insert screw and tighten down special tool 11 9 292 on cylinder
head.
Remove chain tensioning piston.
Insert special tool 11 9 340 in cylinder head and bring adjusting
screw by hand on clamping rail into contact but do not pretension
timing chain yet.
RA Adjusting camshaft timing (N46T)
BMW AG - TIS
23.01.2013 18:07
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
