3 Series E93 320i (N46T) CONVER
Lift out shift arm (1).
Installation:
Grease bearing pin.
Grease,
refer to BMW Service Operating Fluids.
Release screws.
Tightening torque: 23 00 1AZ
.
Important!
Do not suspend the transmission from the transmission input
shaft during removal and installation as this will deform the
clutch plate. Pull out transmission towards rear and remove.
Installation:
Check dowel sleeves (1 and 2) for correct seating.
Replace damaged sleeves.
Ensure correct position of cover plate.
Installation:
Check lubrication of transmission input shaft for sticky
consistency. If grease is sticky, clean input shaft and replace
clutch plate.
.
Check clutch plate for friction rust in splines and replace if
necessary.
Remove any grease and lining abrasion from splines of clutch
plate by mechanical means (with a cloth).
RA Removing and installing transmission (GS6-17BG)
BMW AG - TIS
23.01.2013 19:48
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -
