3 Series E93 320i (N46T) CONVER
Cut open cable tie (1).
Disconnect plug connections (2).
Installation:
Check plug connections for moisture and corrosion. To do so,
read and follow notes/information at the start of the document.
Plug connections must audibly snap into place.
Make sure connecting lead is correctly laid.
Release nuts and remove screws (1) towards bottom.
Remove steering gear (2) towards front.
Installation:
Replace screws and nuts.
Tightening torque 32 00 1AZ
.
After installation:
•
Replacement: Carry out programming/coding
•
Teach in end stop software
•
Perform chassis alignment check
•
Carry out steering angle sensor adjustment
RA Removing and installing (replacing) electric steering gear (EPS)
BMW AG - TIS
23.01.2013 20:57
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -