3 Series E93 320i (N46T) CONVER
Release screws and remove cable duct (1).
Release screw.
Tightening torque 54 34 19AZ
.
Slacken hexagon nut (1).
Twist out barrel screw (2) until wiring harness can be removed
between body and frame (3).
Installation:
Bring barrel screw into contact with special tool 54 0 180 in
conjunction with special tool 00 9 450 .
Tightening torque 54 34 22AZ
.
Carry over the work step shown symmetrically to the other side of
the vehicle.
Release bolts (1).
Tightening torque 41 62 1AZ
.
Remove rear lid.
Installation:
•
Install rear lid at screw locations on hinge.
This dispenses with the need for adjustment after installation.
If necessary, adjust rear lid.
RA Removing and installing rear lid
BMW AG - TIS
23.01.2013 23:16
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -