3 Series E93 320i (N46T) CONVER
Bring gauge with stop for X- and Z-axes into contact with cowl
panel.
Important!
Adjustment work should be carried out by one person only.
Adjust adjusting screws without exerting force.
Cowl panel gauge must rest without play on cowl panel trim strips (partially only point contact).
Centre cowl panel gauge by means of adjusting screw to cowl panel (alignment of Y-axis).
In this way, the base plates are positioned with respect to the vehicle.
Set identical value on scale on both sides (this value may differ from vehicle to vehicle because of the body
tolerances). Signs (+ or -) must be identical on both sides.
Installation:
Screw down base plates on cowl panel.
Tightening torque: 54 37 23AZ
.
The windscreen cowl panel gauge can be raised in the Z-direction by screwing down the base plates (gap
RA Gauging base plate (cowl panel fastener)
BMW AG - TIS
24.01.2013 01:44
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -