3 Series E93 325d (M57T2) CONVER
51 71 482
Removing and installing/replacing left or right
tension strut (on rear axle) (from 03/2007)
Important!
Observe safety instructions for raising the vehicle
Driving without the tension strut is not permitted!
Left tension strut:
Release bolts (1, 3, 4, 5) and remove left tension strut (2).
Installation:
Replace screw (3).
Make sure screws are installed in correct positions.
•
Screw (1) M12x35
Tightening torque 51 71 21AZ
.
•
Screw (3) M12x50
Tightening torque 51 71 22AZ
.
•
Screw (4) M10x25
Tightening torque 51 71 23AZ
.
•
Screw (5) M10x25
Tightening torque 51 71 20AZ
.
Right tension strut:
Note:
Remove left tension strut.
Release screws (1, 3) and remove right tension strut (2).
Installation:
Make sure screws are installed in correct positions.
•
Screw (1) M12x35
Tightening torque 51 71 21AZ
.
•
Screw (3) M10x25
Tightening torque 51 71 20AZ
.
RA Removing and installing/replacing left or right tension strut (on rear axle) (fr
BMW AG - TIS
26.01.2013 09:46
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
