3 Series E93 325d (M57T2) CONVER
Version with seat heater and/or with seat occupancy detector
(OC3 mat):
Release the corresponding plug connections depending on the
version and disconnect.
Detach cable tie.
Pull seat cover (1) with support forward a little and feed
cable (2) out.
Remove seat cover (1) with support towards front/top.
Important!
Feed the wiring harness carefully through the seat and
backrest mechanism as the edges of the frame can be sharp.
Replacing seat cover:
Version with OC3 mat:
-
OC3 mat must not be kinked under any circumstances.
Carefully detach all retainers in side area from longitudinal
wires (1).
Pull trim wires (1) forward out of seat cover.
Carefully fold back seat cover and release retainers from cross-
wires (2).
Remove seat cover from padding.
Important!
Remove all remnants of clips from seat cover and padding.
Padding (1) with OC3 mat (2).
Important!
No retainer remainders may be fitted as well.
Handle OC3 mat with extreme care.
Do not kink OC3 mat.
Do not clamp OC3 mat.
OC3 mat must lie without folds under seat cover.
Installation:
Bend new clips (2) with special tool 52 0 050 .
1.
Padding
2.
Retainer
3.
Trim wire in padding
4.
Trim thread in cover
5.
Seat cover
RA Replacing cover for left or right front seat
BMW AG - TIS
26.01.2013 09:54
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
