3 Series E93 325d (M57T2) CONVER
Observe screwing sequence for support block (4).
Turn banjo bolt (2) back.
Tighten nut (1).
Tightening torque: 54 37 25AZ
.
Insert banjo bolt lock (2) until contact is made with body.
Tighten nut (3).
Tightening torque: 54 37 25AZ
.
Release screw (1).
Move support element (2) upwards to maximum extent.
Insert screw (1) until contact is made.
It must still be possible to slide the support element (2).
Insert screw (1) until contact is made.
It must still be possible to slide the guide element (2).
Stow roof module.
Storage element (3) adjusts itself to support height.
Guide element (2) slides into correct position.
Extend roof module until support block is accessible.
Tighten screws (1) and (4).
Installation:
Install trim for support block.
RA Removing and installing support block
BMW AG - TIS
26.01.2013 10:17
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
