3 Series E93 325d (M57T2) CONVER
54 37 090
Removing and installing/replacing front cowl
panel fastener
Necessary preliminary tasks:
•
Remove roofliner at front
Installation:
•
Microencapsulated screws (Loctite) must be replaced and
may not be reused
•
Screw connection must be completed within 20 mins. (start of
curing)
•
Microencapsulated screws must not be retightened
•
Thread of nut must be cleaned beforehand in event of
repeated use
Move convertible top into service position.
Move convertible top so that angle of hinges is not
≤
90
°
.
Important!
Risk of damage! Pressure in hydraulic system drops and
convertible top loses its position.
Support rear roof shell to convertible top cover with suitable
auxiliary material.
Auxiliary material must lie over wide area and if possible over
entire length.
Rear roof shell is supported by auxiliary material on convertible top
cover.
Roof shells block each other.
RA Removing and installing/replacing front cowl panel fastener
BMW AG - TIS
26.01.2013 10:31
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
