3 Series E93 325d (M57T2) CONVER
Screw on new fasteners loosely.
Fastener should still be able to be slid in order to centre itself.
Install roof shell without roofliner.
Close convertible top.
Installation:
Guide cylinder must run into counter-support without noises and
tension.
Check gap (A) and and adjust if necessary.
(A) = 19 mm
Fasteners glide into place.
Adjust gap (A) = approx. 19 mm.
Tighten down screws.
Tightening torque 54 37 07AZ
.
Left half of picture:
Right half of picture:
1. Screw on new centre fastener loosely.
6.
Mark screw position (1) and open convertible
top.
2. Fastener should still be able to be slid in order to
centre itself.
7.
Slide centre fastener 0.5 mm in direction of
travel.
3. Install roof shell without roofliner.
8.
The required pretension is thus obtained.
4. Close convertible top.
9.
Tighten down screws (1). Tightening torque
54 37 07AZ
.
5. Fastener centres itself.
RA Removing and installing/replacing complete front roof shell fastener pack
BMW AG - TIS
26.01.2013 10:32
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -