3 Series E93 325d (M57T2) CONVER
Drive out bearing pins (1 and 2).
Installation:
Bearing pin (1) is shorter than bearing pin (2).
Remove hydraulic cylinder.
Unfasten plug connection (1) and disconnect.
Note:
Plug connection on right roof shell cylinder can be incorrectly
positioned.
The plug connection must be repositioned if it does not point to
the outside of the vehicle.
Disconnecting hydraulic lines from cylinder:
Disconnect cable straps.
Installation:
Replace cable straps.
Slide open retaining rings (1) with screwdriver.
Detach hydraulic lines (2).
Important!
Protect joints (lines and cylinder) against dripping fluid, e.g.
with a cleaning cloth.
Observe hose markings.
Make sure airbag hydraulic lines and wiring harness are
exactly routed.
Note:
-
Carry out operational check.
-
Check fluid level.
RA Removing and installing/replacing right hydraulic cylinder from roof shell, midd
BMW AG - TIS
26.01.2013 10:36
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -