3 Series E93 325d (M57T2) CONVER
54 37 260
Replacing rear-end module Hall sensor on
partition wall
Necessary preliminary tasks:
•
Open convertible top compartment lid.
Installation:
•
Microencapsulated screws (Loctite) must be replaced and
may not be reused
•
Screw connection must be completed within 20 minutes (start
of curing)
•
Microencapsulated screws must not be retightened
•
Clean thread of nut beforehand in event of repeated use
Unfasten plug connection (1) and disconnect.
Release screw (2).
Unclip wiring harness.
Feed out Hall sensors.
Installation:
Hall sensor for convertible top cover must be readjusted.
If there is no signal from the Hall sensors, perform the following
adjustments:
RA Replacing rear-end module Hall sensor on partition wall
BMW AG - TIS
26.01.2013 10:40
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
