3 Series E93 325i (N52K) CONVER
Unfasten screws (1) and nuts (2).
Remove transmission cross-member.
Tightening torque 24 71 1AZ
.
-
Remove propeller shaft from transmission.
-
Release centre bearing.
-
Tie propeller shaft to one side.
Tasks are described in Removing propeller shaft.
Important!
Do not allow propeller shaft to hang from fixed ball joint (risk
of damage).
Crank engine at vibration damper in direction of rotation until
screw (1) is visible in opening.
Release all screws of torque converter with special tool
24 1 110 .
Crank engine further and release remaining 5 bolts.
Tightening torque 24 40 1AZ
.
Insert special tool 24 1 370 into opening of transmission
housing and secure with screw (1).
Note:
Check installation location.
Lug (2) must point in opposite direction to direction of travel.
RA Removing and installing automatic transmission (GA6L45R)
BMW AG - TIS
30.01.2013 04:59
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -