3 Series E93 325i (N52K) CONVER
33 32 190
Removing and installing/replacing left or right
camber arm
Warning!
Scalding hazard!
This work may only be carried out on an exhaust system
which has cooled down.
Note:
If the camber arm is detached from the rear axle carrier/wheel
carrier, it is necessary after reinstallation to carry out a
wheel/chassis alignment check.
Necessary preliminary tasks:
•
Remove coil spring at rear
•
Remove rubber mount for shock absorber mounting on
camber arm
•
Remove jointed rod of ride-height sensor from camber arm
bracket
Support wheel carrier with workshop jack.
Mark position of eccentric screw (1) to camber arm.
Replacement only: Carry over marking from old part to new part.
Release nut (2) and remove bolt towards rear.
Installation:
Note insertion direction of bolt.
Replace self-locking nut.
Tightening torque 33 32 10AZ
.
RA Removing and installing/replacing left or right camber arm
BMW AG - TIS
30.01.2013 07:02
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -