3 Series E93 325i (N52K) CONVER
41 21 540
Replacing front left outer door pillar section
Read contents of Body, General.
For stripping and rigging operations, refer to texts on KSD
CD (FR number 41 32 010).
Spot-weld bonding is used on this vehicle. Observe specific
procedure.
Remove or cover those vehicle components in the repair area
which are susceptible to heat or dust.
Use only approved spot-welding apparatus for repairs!
Place vehicle on straightening bench.
Necessary preliminary tasks:
•
Remove front side panel
Following new body parts are required (refer to Electronic Parts
Catalogue ETK):
-
(1) Support carrier, wheel arch, outer
-
(2) Door hinge, top left
-
(3) A-pillar, outer
Mark severance cut in accordance with specified measurement
and cut.
Important!
Cut outer metal sheet only.
Measurement a = approx. 130 mm from edge of rectangular
hole.
Open weld joint in area (1).
RA Replacing front left outer door pillar section
BMW AG - TIS
30.01.2013 08:50
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
