3 Series E93 325i (N52K) CONVER
54 62 005
Removing and installing/replacing rollover
protection system
Special tools required:
•
00 9 450
•
54 0 180
•
54 0 190
Warning!
Risk of injury!
When the actuators are electrically activated, there must be
no persons present in the vicinity of the rollover protection
system.
When a rollover bar is mechanically triggered, only one
person may be present underneath the rollover bar.
Important!
When the actuators are activated, both rollover bars are
simultaneously triggered.
Trigger rollover bars.
Installation:
•
Microencapsulated screws (Loctite) must be replaced and
may not be reused
•
Screw connection must be completed within 20 minutes (start
of curing)
•
Microencapsulated screws must not be retightened
•
Clean thread of nut beforehand in event of repeated use
RA Removing and installing/replacing rollover protection system
BMW AG - TIS
30.01.2013 12:23
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -