3 Series E93 328i (N51) CONVER
Clean sealing faces (1).
Important!
Do not clean sealing faces with a metal-cutting tool.
Clean sealing faces (1) with special tool 11 4 470 .
Insert all bearing shells (2 and 3).
Note:
Bearing shell at the fourth bearing block is a thrust bearing.
Determine bearing play with special tool 00 2 590 .
Installation:
All measuring points must be free from oil and grease.
Use used screws to determine bearing play.
Set up crankcase lower section with bearing shells.
Remove lower crankcase.
Read off bearing play at width of flattened plastic thread and
measurement scale.
Crankshaft bearing clearance radial.
Installation:
Remove plastic thread.
Apply a light coat of oil to bearing shells and crankshaft.
RA Replacing all crankshaft main bearings (N51)
BMW AG - TIS
04.02.2013 19:54
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
