3 Series E93 328i (N51) CONVER
11 31 025
Removing and installing/replacing inlet
camshaft (N51)
Special tools required:
•
11 4 281
•
11 4 481
Important!
Aluminium screws/bolts must be replaced each time they are
released.
The end faces of aluminium screws/bolts are painted blue for
the purposes of reliable identification.
Jointing torque and angle of rotation must be observed
without fail (risk of damage).
Necessary preliminary tasks:
•
Remove cylinder head cover.
•
Remove adjusting unit for inlet camshaft.
•
Remove intermediate lever.
•
Adjust valve timing.
Bearing cap (1) is a thrust bearing.
Release screws of bearing caps (1 and 2).
Set all bearing caps down in special tool 11 4 481 in a tidy and
orderly fashion.
All bearing caps are identified from 1 to 6.
Tightening torque: 11 31 1AZ
.
RA Removing and installing/replacing inlet camshaft (N51)
BMW AG - TIS
04.02.2013 20:01
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
