3 Series E93 328i (N51) CONVER
Fit guide block (2) cleanly into opening.
Tighten bolts (1) hand-tight.
Check both intermediate levers again to ensure correct installation
position.
Release bolts (1) again by a 1/4 turn.
Secure special tool 11 4 450 to bolt connection (1) of eccentric
shaft.
Turn eccentric lever (3) on special tool 11 4 450 in direction of
arrow.
Guide block is now tensioned.
Secure bolts (2).
Tightening torque: 11 37 1AZ
.
Installation:
At cylinder no. 3, the guide block can be pre-installed with one
bolt (2) only.
Fit oil pump only after retaining spring has been fitted.
Fit return spring on guide block.
Installation:
Insert return spring (2) in intermediate lever (1) (see arrow).
Check roller cam follow (3) again to ensure correct installation
position.
Secure special tool 11 4 270 with gripping pliers (3) to guide
block (1).
Important!
Special tool 11 4 270 is only secured to guide block.
Adjusting the gripping pliers (3) is not permitted (risk of
damage) on special tool 11 4 270 .
RA Removing and installing/replacing intermediate lever (N51)
BMW AG - TIS
04.02.2013 20:07
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -
