3 Series E93 328i (N51) CONVER
54 37 ...
Removing and installing/replacing rear roof
shell fastener
Necessary preliminary tasks:
•
Support convertible top compartment lid in service position
•
Remove rear roofliner
Installation:
•
Microencapsulated screws (Loctite) must be replaced and
may not be reused
•
Screw connection must be completed within 20 min. (start of
curing)
•
Microencapsulated screws must not be retightened
•
Thread of nut must be cleaned beforehand in event of
repeated use
Note:
Before removing, mark position of screws to ensure correct
alignment when installing.
Release screws (1).
Tightening torque: 54 37 11AZ
.
Replacement only:
Slide locking element upwards fully and screw on loosely.
Locking element should still be able to be slid in order to centre
itself.
Install roof shell without roofliner.
Close convertible top.
Locking element glides into place.
Open convertible top.
Tighten down screws (1).
Tightening torque: 54 37 11AZ
.
RA Removing and installing/replacing rear roof shell fastener
BMW AG - TIS
05.02.2013 05:08
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -