3 Series E93 328i (N51) CONVER
72 11 030
Removing and installing or replacing front
seat belt
Important!
Read and comply with safety regulations for handling airbag
modules and pyrotechnical belt pretensioners.
Inexpert handling can trigger off the airbag or the belt
pretensioner and thereby cause injuries.
If a seat belt which is damaged due to an accident is
exchanged, always check the affected seat for damage.
Necessary preliminary tasks:
•
Remove front seat
•
Remove and install rear panel on front seat
•
Remove trim cover for outer fitting
•
Remove inner cover on front seat
•
Partially detach seat cover
•
Partially detach backrest cover
Important!
Do not detach coupling gear from flex shaft.
If a new belt system is fitted, always use a new coupling gear.
If a new coupling gear is fitted, always replace the top belt.
Removing inertia reel with flex shaft and coupling gear:
Release screw.
Installation:
Replace microencapsulated screw.
Tightening torque 72 11 02AZ
.
Remove end fitting.
RA Removing and installing or replacing front seat belt
BMW AG - TIS
05.02.2013 10:21
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -