3 Series E93 328i (N52K) CONVER
54 37 080
Removing and installing/replacing roof shell
at rear
Necessary preliminary tasks:
•
Remove roofliner for roof shell
•
Measure and note down gap dimensions
Installation:
•
Microencapsulated screws (Loctite) must be replaced and
may not be reused
•
Screw connection must be completed within 20 min. (start of
curing)
•
Microencapsulated screws must not be retightened
•
Thread of nut must be cleaned beforehand in event of
repeated use
Move convertible top into service position.
Move convertible top so that angle of hinges is not
≤
90
°
.
Important!
Risk of damage! Pressure in hydraulic system drops and
convertible top loses its position.
Support rear roof shell to convertible top cover with suitable
auxiliary material.
Auxiliary material must lie over wide area and if possible over
entire length.
Rear roof shell is supported by auxiliary material on convertible top
cover.
Roof shells block each other.
RA Removing and installing/replacing roof shell at rear
BMW AG - TIS
06.02.2013 17:44
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
