3 Series E93 330d (M57T2) CONVER
Important!
Danger of breakage of pressure line on injector! Observe
tightening torque without fail.
Tightening torque 13 53 1AZ
.
1.
Hand-tighten all union nuts on pressure lines.
2.
Tighten down union nuts on injectors and on pressure
accumulator to specified torque.
3.
Inspect all components of Common Rail System for leaks.
Note:
In the case of piezo injectors, the seven-digit adjustment value
must be stored in the control unit after an injector has been
replaced.
Read off adjustment value (1) on new injector (2).
Note:
If injectors have been replaced, "Injector map adjustment"
must be carried out:
1.
Connect DIS Tester
2.
Identify car
3.
Select "Function selection"
4.
Select "Service functions"
5.
Select "Digital Diesel Electronics (DDE)"
6.
Select "Injector adjustment"
7.
Select "Test schedule"
8.
Start Service functions with right arrow key.
Note:
Now clear the fault memory.
RA Removing and installing/replacing all injectors of fuel injection system (M57T2)
BMW AG - TIS
07.02.2013 14:52
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -