3 Series E93 330d (M57T2) CONVER
Remove transmission cross-member.
Release screws and remove transmission supporting block from
transmission.
Tightening torque 24 71 6AZ
.
Note:
Illustration shows E65.
Release propeller shaft from transmission and centre mount and
tie to one side.
Note:
To rotate propeller shaft, unlock parking gear.
Grip output flange (1) with special tool 23 0 020 .
Release nut with special tool 24 2 380 .
Tightening torque: 24 13 2AZ
.
Installation:
Replace nut and secure with a mandrel (8 mm) by caulking.
RA Replacing output flange shaft seal (GA6HP26Z/6HP32Z)
BMW AG - TIS
07.02.2013 16:15
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -