3 Series E93 330d (M57T2) CONVER
51 71 ...
Removing and installing/replacing rear middle
tension strut (from 03/2007)
Important!
Observe safety instructions for raising the vehicle
Driving without the tension strut is not permitted!
Release bolts (1, 2, 4) and remove tension strut (3).
Installation:
First fasten all bolts provisionally and then tighten down.
•
Screw (1) M12x50
Tightening torque 51 71 22AZ
.
•
Screw (4) M8x25
Tightening torque 51 71 13AZ
.
Important!
Rear tension strut must be installed below the right tension
strut!
RA Removing and installing/replacing rear middle tension strut (from 03/2007)
BMW AG - TIS
07.02.2013 23:19
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
