3 Series E93 330d (M57T2) CONVER
54 37 205
Removing and installing/replacing right
coupling fastener hydraulic cylinder
Necessary preliminary tasks:
•
Remove side trim upper section
Caution!
Hydraulic fluid may emerge from the disconnected lines and
the open connections on the hydraulic cylinder.
Protect components and work area with suitable materials
(e.g. cloths).
Note:
Hydraulic system must be at zero pressure.
Open screw on hydraulic unit 1.5 turns.
Removing hydraulic cylinder:
-
Slide retaining clip (1) upwards.
-
Detach ball socket at side.
-
Remove retaining ring (2).
-
Drive through bearing pin (3).
-
Feed out hydraulic cylinder.
RA Removing and installing/replacing right coupling fastener hydraulic cylinder
BMW AG - TIS
08.02.2013 00:28
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
