3 Series E93 330d (M57T2) CONVER
Check basic gauge for contact at all four contact points.
Note:
On account of the body tolerances there may be on one side a
gap dimension between extension arm and body.
Do not exert any pressure on the extension arms.
Important!
Adjustment work should be carried out by one person only.
Adjust knurled screws without exerting force.
Centre basic gauge with knurled screw to body.
Set identical value on scale on both sides (this value may differ from vehicle to vehicle because of the body
tolerances). Signs (+ or -) must be identical on both sides.
Basic gauge must rest without play on inner side panel.
RA Aligning basic gauge
BMW AG - TIS
08.02.2013 00:08
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
