3 Series E93 330d (M57T2) CONVER
Installation:
Plastic washer on end fitting must be fitted!
End fitting is coded to prevent incorrect installation.
Unclip all cables from guides.
Release screw (1).
Tightening torque: 72 11 09AZ
.
Release stud (2).
Tightening torque: 72 11 08AZ
.
Note:
Replace driver (1) after removal with a new component as
damage cannot be excluded.
When removing driver (1), ensure guide (3) and lever (2) of
coupling gear are not damaged.
Remove driver (1) from backrest shaft.
Installation:
Do not fit new driver (1) on backrest shaft yet.
Backrest must be in as vertical a position as possible.
Driver (1) and lug are positioned at an angle towards top in
direction of travel (arrow).
RA Removing and installing or replacing front seat belt
BMW AG - TIS
08.02.2013 04:52
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
