3 Series E93 330i (N53) CONVER
51 71 482
Removing and installing/replacing left or right
tension strut (on rear axle) (up to 03/2007)
Important!
Observe safety instructions for raising the vehicle
Driving without the tension strut is not permitted!
Release screws (1, 2, 3).
Remove tension strut (4).
Installation:
Replace screw (2).
Make sure screws are installed in correct positions.
•
Screw (1) M12x35
Tightening torque 51 71 25AZ
.
•
Screw (2) M12x50
Tightening torque 51 71 26AZ
.
•
Screw (3) M10x25
Tightening torque 51 71 20AZ
.
Important!
Left tensions strut (1) must be installed under right tension
strut (2).
RA Removing and installing/replacing left or right tension strut (on rear axle) (up
BMW AG - TIS
10.02.2013 17:17
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
