3 Series E93 330i (N53) CONVER
Note:
Before removing, mark position of screws to ensure correct
alignment when installing.
Release screws (1).
Tightening torque 54 37 09AZ
.
Note:
The scope of work for removing and installing the roof shell
fastener ends here.
Check gap dimensions and if necessary adjust
Screw on fastener loosely.
Fastener should still be able to be slid in order to centre itself.
Close convertible top.
Fastener centres itself.
Mark screw position and open convertible top.
Slacken screws and slide centre fastener 0.5 mm in opposite
direction to direction of travel.
The required pretension is thus obtained.
Tighten down screws (1).
Tightening torque 54 37 09AZ.
Check gap dimensions and if necessary adjust
RA Removing and installing/replacing fastener for roof shell in middle
BMW AG - TIS
11.02.2013 00:11
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
