3 Series E93 335i (N54) CONVER
Clean bevel pinion thoroughly to remove remnants of screw-
locking agent.
Check dust cover for damage, replace if necessary.
Important!
Clean flange nut thoroughly to remove remnants of grease
and screw-locking agent.
Pack collar insert (1) of flange nut with grease.
Apply a thin coating of grease to shaded area (2) of flange
nut.
Coat at least four thread turns of flange nut with
"DREI BOND adhesive type 1385".
Important!
In order to avoid damaging the rear differential, do not under
any circumstances tighten down the flange nut (1) beyond
the marker point of the bevel pinion (2).
Place insert nut (2) with diaphragm seal in flange nut.
Install retaining clip (1).
RA Replacing shaft seal for drive flange on rear differential (inserted propeller s
BMW AG - TIS
12.02.2013 06:05
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
