3 Series E93 335i (N54) CONVER
33 21 000
Removing and installing/replacing left or right
output shaft (on 2-flow exhaust system)
Remove rear wheel.
Important!
Expand turning lock sufficiently to avoid damaging thread
when releasing collar nut.
Release collar nut (1), activate handbrake for this purpose.
Installation:
Replace collar nut, oil collar nut/wheel bearing contact surface
only and tighten down.
No oil permitted on thread of shaft journal or collar nut.
Tightening torque 33 41 1AZ
.
Secure collar nut by positive peening on flat areas of output shaft.
E91, E93: Remove tension strut (on rear axle).
Except M3: Lower exhaust system in rear area.
M3: Remove final muffler.
Release bolts and remove with washers (1).
Press output shaft off drive flange using a suitable tool; if
necessary, raise wheel carrier with workshop jack approx.
20 mm.
Installation:
Before installing output shaft, make sure that drive flange is fully
engaged in rear differential.
Replace bolts and washers (1).
Tightening torque 33 21 1AZ
.
RA Removing and installing/replacing left or right output shaft (on 2-flow exhaust
BMW AG - TIS
12.02.2013 06:11
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -