3 Series E93 335i (N54) CONVER
If necessary, remove roof hinge bracket:
Release nuts (1) on roof hinge bracket.
Installation:
Replace nuts.
Screw on bracket loosely.
Bracket should still be able to be slid in order to centre itself.
Close convertible top.
Screw down rear nut and open convertible top.
Screw down front nut.
Tightening torque: 54 37 10AZ
.
Important!
Lock barrel screws with a flat wrench without fail.
Mark screws (1) and release.
Tightening torque: 54 37 05AZ.
Remove roof shell.
Note:
Plug connection on right roof shell cylinder can be incorrectly
positioned.
The plug connection must be repositioned if it does not point to
the outside of the vehicle.
Note:
The scope of work for removing and installing the roof shell ends
here.
Replacement only:
Remove fastener, roof shell, middle (1) .
Remove seal, roof shell, middle (2) .
RA Removing and installing/replacing roof shell in middle
BMW AG - TIS
12.02.2013 12:21
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
