Replacing Input Bevel Gear and Crown Wheel - Final Drive Housing Removal - Page 870
Remove differential for installation of the drive pinion.
(If final drive housing bearings were not replaced, procedures can
be continued from this point.)
Caution!
Match side covers ad corresponding shims of determined
thickness; don't mix them up.
Install drive pinion with a new clamping sleeve (2).
Immerse shaft seal in final drive oil and drive home flush with
special tool 33 1 270 in conjunction with special tool 00 5 500
(handle).
Press-fit input flange to the input shaft using special tool
23 1 300 but do not tighten down.
The axial preload force of drive pinion bearings (5000 N) can be
determined with help of the friction torque.
RA Replacing input bevel gear and crown wheel (Type M) - final drive housing remove
BMW AG - TIS
20.01.2013 20:13
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 15 -
