5 Series E34 525ix (M50) SAL
Note:
The cylinder head cover is separated from the cylinder head
by rubber mounts and seals to prevent oscillation.
1 Cap nut
2 Washer
3 Rubber
Installation:
Clean gasket residue from sealing surfaces.
Coat contact surfaces of joint with Drei Bond 1209 (refer
to BMW Parts Service).
Installation:
Clean gasket residue from sealing surfaces.
Apply a thin, uniform bead of Drei Bond 1209 sealing agent
(refer to BMW Parts Service) to transition area of half-moon
sections.
Installation:
Check gaskets and replace if necessary.
Place seals on cylinder head.
RA Removing and installing or sealing cylinder head cover (M50)
BMW AG - TIS
21.01.2013 20:29
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -