5 Series E34 525ix (M50) SAL
Mark plug-in connection (2) on wiring harness and disconnect it.
Installation:
Interrogate fault memory of engine control unit, eliminate
stored faults and erase the fault memory.
1 = Plug connection on oil pressure switch
2 = Sensor for cylinder recognition
3 = Impulse sensor on vibration damper
Remove sensor.
Installation:
Ensure correct seating of O-ring.
Interrogate fault memory of engine control unit, eliminate stored
faults and erase the fault memory.
M50 with VANOS (= Variable Camshaft Spread)
Disconnect solenoid valve plug-in connection on VANOS
adjustment unit.
Unscrew solenoid.
Installation:
Check seal, replacing if necessary.
For tightening torque, refer to Technical Data 11 36 1AZ
RA Replacing sensor for cylinder recognition (M50 direct ignition system)
BMW AG - TIS
21.01.2013 20:39
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
