5 Series E34 530i (M30) SAL
Compress gear train at 5th/reverse gear sliding sleeve with
countershaft with special tool 23 2 250.
Attach special tool 23 2 370 to output shaft and countershaft.
Attach special tool 23 1 050 to housing sealing surface and
center of special tool 23 2 370 .
Caution!
Use a piece of wood, plastic or similar on the sealing
surfaces.
Press out gear train and countershaft uniformly.
When pressing out, make sure gear train and countershaft do not
get jammed.
Installation:
The bearings or elements of the bearing brackets could be
damaged while pressing out the drive and output shafts.
Always replace bearing and segments during removal.
Remove gear train with 1st/2nd and 3rd/4th gear shift arms and
countershaft.
RA Removing and installing complete drive and output shafts (S5D 260Z / 310Z / 320Z
BMW AG - TIS
25.01.2013 00:40
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 7 -