5 Series E34 530i (M30) SAL
Detach drive shaft (1), synchronizer ring (2) and roller bearing (3).
Grip gear train at output shaft (use protective vise jaws).
Detach 5th/reverse gear sliding sleeve.
Caution!
Loose thrust pieces, balls and springs.
Remove retaining ring (4) and spacer (5).
Installation:
Replace retaining ring (4).
Move 1st/2nd gear sliding sleeve in direction of 2nd gear.
Position press-off supports on 1st gear wheel.
Press following parts off output shaft:
-
Guide sleeve
-
Reverse gear wheel with synchronizer ring
-
Needle bearing
-
Bearing sleeve
-
1st gear wheel
-
Thrust washer
Pull off following parts:
-
Needle bearing
-
Synchronizer ring
-
Intermediate ring
-
Outer race
RA Disassembling and assembling all synchronizing mechanisms (S5D 260Z / 310Z / 320
BMW AG - TIS
25.01.2013 00:41
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -