5 Series E39 520d (M47) SAL
Withdraw special tool 13 5 190.
Fit central nut and tighten to approx. 15 Nm (initial tightening).
Release blocking screw (1) on injection pump.
Insert spacer (2) and tighten down locking screw.
Note:
Spacer (2) is enclosed loose with new or replaced injection
pumps.
Tightening torque,
refer to Technical Data 13 51 14AZ.
Pull out special tool 11 2 300.
Tighten down central nut on injection pump.
In doing so, grip crankshaft at front central bolt.
Tightening torque,
refer to Technical Data 13 52 2AZ.
Open oil filler neck.
Crank engine slowly in direction of rotation until cast lug (1) on
inlet camshaft points upwards.
Note:
Cast lug (1) on inlet camshaft points upwards at firing TDC,
cylinder 1.
RA Removing and installing/replacing injection pump (M47)
BMW AG - TIS
22.01.2013 23:24
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 10 -