5 Series E39 520d (M47) SAL
18 00 020
Removing and installing complete exhaust
system M47
Remove splash guard from unit.
Release hexagon nuts (1/2) and remove reinforcement (3).
Release hexagon nuts (5) and remove reinforcement (6).
E46 only:
Bracket (4) can remain on transmission.
Unfasten hex nuts (1). Detach primary catalytic converter (2)
towards rear from turbocharger.
Check sealing surfaces, clean if necessary.
Installation:
Replace self-locking nuts.
Coat thread with copper paste -CRC-, refer to BMW Parts
Service.
Support exhaust system with lifting equipment.
Release hexagon screws (1/2) and remove reinforcement plates
(3/4).
This illustration shows the E46.
The E39 car only has one reinforcement plate.
RA Removing and installing complete exhaust system M47
BMW AG - TIS
23.01.2013 00:25
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -