5 Series E39 520d (M47) TOUR
Compare setting values next to nameplate and on dial gauge
(tolerance
±
0.1 mm).
Note:
If the pointer on the dial of the special tool 00 2 510 (dial
gauge) has not moved, the injection pump is in the overlap
TDC position.
Pull special tool 11 2 300 back until flywheel is no longer
secured in position.
Crank engine at central bolt once in direction of rotation until
piston is again in TDC position.
The injection pump is now in the firing TDC position.
Note:
If necessary, check setting value of injection pump with
special tool 00 2 510 (dial gauge) again.
Installation:
Installation of cylinder head is described separately from removal.
The assembly sequence differs between removal and installation.
Clean sealing faces of cylinder head and engine block; if
necessary, remove traces of sealing compound with hardwood
spatula. While proceeding, make sure that no remnants of sealing
compound drop into the oilways and cooling ducts.
Without work on the engine block which changes the piston
protrusion, use a new cylinder head gasket with the same
thickness marking (number of holes).
RA Removing and installing cylinder head (M47)
BMW AG - TIS
23.01.2013 22:29
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 9 -
