5 Series E39 520d (M47) TOUR
Installation:
Replace seal.
Apply a thin coat of Drei Bond 1209 sealing compound (refer
to BMW Parts Service) to front and rear ends of seal.
Install timing case cover, insert all screws and initially tighten to
approx. 5 Nm.
Firmly tighten all screws in alternate sequence.
Note:
M7 screws.
Tightening Torque,
refer to Technical Data 11 14 1AZ.
Caution!
If all screws are tightened, they must be tightened again in a
second operation.
Replace radial seal,
refer to 11 14 141.
Assemble engine.
RA Removing and installing, sealing/replacing timing case cover at bottom (M47)
BMW AG - TIS
23.01.2013 22:44
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
