5 Series E39 520d (M47) TOUR
Pull lock (1) and detach water hoses.
Installation:
Refer to general instructions for work on cooling system.
Release screw on coolant connecting line.
Note:
Screw with M7 thread.
Installation:
Replace sealing ring.
Install screw and tighten down.
Tightening Torque,
refer to Technical Data 11 51 1AZ.
Disconnect charge air hose from EGR valve.
Installation:
Fit charge air hoses without grease and dry.
Unscrew bolt (1).
Pull lock (2) and detach water hose.
Remove coolant connecting line.
Release screws on thermostat housing, remove thermostat
housing.
RA Removing and installing or replacing coolant thermostat (M47)
BMW AG - TIS
23.01.2013 23:23
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -